Post

mandicreally.com
@mandicreally.com

THURSDAY LIVE! Rebuilding my Voron 2.4 3D Printer, this time the Wiring Begins! We are going to route and custom cable sleeve the Umbilical cable for the BigTreeTech SB2209 USB board and the Z-Umbilical cable. Check it out on Mandic Labs at 4PM PST 1/2/25: youtube.com/live/7sIqnPL...

2 reposts14 likes

Jon Charnas
@3detplus.bsky.social

Oof, careful with that toolhead board. Mine was wired exactly right, worked for a few hours, then I power cycle my machine overnight (i.e. off for the night on in the morning), two snap sounds and magic smoke after 2s... The USB/24v board dead and my controller too. Backfed 24V over the USB line 😖