kimmoli

had a nightmare... explaining EMC in onlyfans chat...

When your shipment gets stuck in UPS limbo. World Ease.

It took a while to get parts, but today we'll see do we get Volvo stop being black smoke generator. If not, need to start looking at injectors... Weather should also be ok'ish

Findings from "old" decomissioned TEK scope TDS540

ei lopu hommat ei

Corolla ABS Sensor fixing. Bolt was rusted and self-cutted (same as on other side). First installation wasn't success as there was some debris (aka rust) and sensor did not go deep enough. After cleaning all ok. MOT today. This cause ABS to rattle just before stopping due bad signal on low speeds.

Can't get past this @bsky.app

@bsky.app wut is wrong?

long time no see

When you have no actual schedule for sauna, cheapest hour. (8 kW)

replacement ballast arrived today

my ex-wife, as i sometimes mis she doing exactly that...

Today. Corolla side mirror heater does not work. Lets take a look. there are couple of videos how to take the mirror off, but i want just the glass-element. One of the videos shows how it is easier to reassemble, so i took it apart from that point. (ALT) Spoiler - mirror heating element is död

Without saying your age, what’s your favorite movie that came out when you were 18?

Snowblower test run... pass. "This engine has provisions for Electric Starter Kit" which is a useful reminder after 20-30 pulls. Luckily it started on first. has been off duty for about a year now.

Bought a smoke machine for leak detection instead of new tank to Corolla... It can be used also for hunting downpipe exit point :)

Added pair of new lamps to carage. Now total 31200 lumens.

Also calibrated Corolla electric window AUTO function, which was not working.

Next is fuel leak... the fill pipe seeps through, rusty.

argh

During this project, side project was to make stairs for easier access to upper level

Everything except electrical connection on car side, and outer plastic bumber in place. Bumber needs a cutout, instructions just says "~70x150 mm" had to fix one mounting bolt, rusty and started to rotate in plastic when taking off. some quick epoxy should hold it enouhg.

Fixed with three bolts per side. 2 of them have existing fixed nuts, in place of original towing hooks. third bolt is deep, but it is supplied with a "handle". part 4. But still took too long to get it in place.

Finally. New parts. This is kinda heavy. And ofcourse it didn't fit and had to cut a piece off.

non-flanged bolt heads, but with inner cavity. needed to file down socket to get full grip. 6/6 opened nicely

Wish me luck

I like my new tool Only negative so far is that i didn't acquire one earlier...

been pulling nails

next 456789

www.youtube.com/watch?v=FFEb...

Todays project was to utilise my excavator winter isolators as walking ramps in my car pit. Removable so i can still use these as intended in winter (to prevent excavator to freeze on ground) Still to do vertical support posts. Old ramp was untreaded populus tremula which started to get soft...